M O N T A G E
Schrauben Sie zunächst die Gewindestangen in die
dafür vorgesehenen Löcher auf der Rückseite der Ziffer.
Nun können Sie die genaue Position der Bohrlöcher auf
ihrem Konturenblatt – wie in der Zeichnung zu sehen –
markieren.
Befestigen Sie anschließend das Konturenblatt an der
Gebäudewand und bohren Sie Löcher mit einem Durchmesser von 5–6 mm.
Um einen festen Halt zu gewährleisten, füllen Sie nun
die Bohrlöcher mit Silikon oder Montagekleber und
setzen die Ziffer ein. Achten Sie bitte darauf, zwischen
Wand und Ziffer einen Abstand von ca. 2 bis 10 mm frei
zu lassen. Damit wird verhindert, dass auf den waagerechten Flächen der Ziffern Staubablagerungen entstehen und bei Regen an der Wand ablaufen.